Position Display

Classic Control - Mill Operator's Manual

The Online Interactive Operator's Manual is currently available in English only.

A PDF version of the Operator's Manual is available for download in multiple languages. Click the link below to view the Operator's Manual in your language. Click "Continue" to view the online version in English.

Get a translated PDF Download Continue

The Position display usually appears near the lower center of the screen. It shows the current axis position relative to four reference points (Operator, Work, Machine and Distance-to-go). In SETUP:JOG mode, this display shows all of the relative positions at the same time. In other modes, press POSITION to cycle through the different reference points.

Axis Position Reference Points

Coordinate Display Function
OPERATOR This position shows the distance you have jogged the axes. This does not necessarily represent the actual distance the axis is from machine zero, except when the machine is first powered on.
WORK (G54) This displays the axis positions relative to part zero. On power-up, this position uses work offset G54 automatically. It will then display the axis positions relative to the most recently-used work offset.
MACHINE This displays the axis positions relative to machine zero.
DIST TO GO This displays the distance remaining before the axes reach their commanded position. When in SETUP:JOG mode, you can use this position display to show a distance moved. Change modes (MEM, MDI) and then switch back to SETUP:JOG mode to zero this value.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.