Machine Power-On

Classic Control - Mill Operator's Manual

The Online Interactive Operator's Manual is currently available in English only.

A PDF version of the Operator's Manual is available for download in multiple languages. Click the link below to view the Operator's Manual in your language. Click "Continue" to view the online version in English.

Get a translated PDF Download Continue

This section tells you how to power-on a new machine for the first time.

  1. Press and hold POWER ON until you see the Haas logo on the screen. After a self-test and boot sequence, the display shows the startup screen.

    The startup screen gives basic instructions to start the machine. Press CANCEL to dismiss the screen.

  2. Turn EMERGENCY STOP to the right to reset it.
  3. Press RESET to clear the startup alarms. If you cannot clear an alarm, the machine may need service. Contact your Haas Factory Outlet (HFO) for assistance.
  4. If your machine is enclosed, close the doors.
  5. warning: Before you do the next step, remember that automatic motion begins immediately when you press POWER UP/RESTART. Make sure the motion path is clear. Stay away from the spindle, machine table, and tool changer.

    The axes rapid toward their home positions. The axes then move slowly until the machine finds the home switch for each axis. This establishes the machine home position.

The control is now in OPERATION:MEM mode. You can now press CYCLE START to run the active program, or you can use other control functions.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.