How To>M88 Through-Spindle Coolant On / M89 Through-Spindle Coolant Off - Mill

M88 Through-Spindle Coolant On / M89 Through-Spindle Coolant Off - Mill

M88 Through-Spindle Coolant On / M89 Through-Spindle Coolant Off

M88 turns on through-spindle coolant (TSC), and M89 turns off TSC.

The control automatically stops the spindle before it executes M88 or M89. The control does not automatically start the spindle again after M89. If your program continues with the same tool after an M89 command, be sure to add a spindle speed command before further motion.

caution: You must use proper tooling, with a through-hole, when you use the TSC system. Failure to use proper tooling can flood the spindle head with coolant and void the warranty.

Sample Program

note: The M88 command should be before the spindle speed command. If you command M88 after the spindle speed command, the spindle starts, then stops, turns on TSC, and then starts again.
% T1 M6 (TSC Coolant Through Drill) ; G90 G54 G00 X0 Y0 ; G43 H01 Z.5 ; M88 (Turn TSC on) ; S4400 M3 ; G81 Z-2.25 F44. R.1 ; M89 G80 (Turn TSC off) ; G91 G28 Z0 ; G90 ; M30 ; %

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback