TOTD Episode 40 - Set a work offset with an edge finder and indicator

In this episode, Mark guides you through the proper use of an edge finder, a dial indicator, and even a high-end 3D sensor, to set your work offsets. Regardless of skill level, these techniques are valuable for any machinist.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback