Type 2 Details

Classic Control - Lathe Operator's Manual

The Online Interactive Operator's Manual is currently available in English only.

A PDF version of the Operator's Manual is available for download in multiple languages. Click the link below to view the Operator's Manual in your language. Click "Continue" to view the online version in English.

Get a translated PDF Download Continue

When Type 2 is specified, the X-Axis PQ path is allowed to vary (for example, the X-Axis tool path can reverse direction).

The X-Axis PQ path must not exceed the original starting location. The only exception is the ending Q block.

Type 2 roughing, when Setting 33 is set to YASNAC, must include R1 (with no decimal) on the G71 command block.

Type 2, when Setting 33 is set to FANUC, must have a reference move, in both the X and Z Axis, in the block specified by P.

Roughing is similar to Type 1 except after each pass along the Z Axis, the tool follows the path defined by PQ. The tool then retracts parallel to the X Axis by a distance defined in Setting 73 (Canned Cycle Retraction). The Type 2 roughing method does not leave steps in the part prior to finish cutting and typically results in a better finish.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback