How To>Setting 131 - Auto Door - Mill

Setting 131 - Auto Door - Mill

Setting 131 - Auto Door

This setting supports the Auto Door option. Set it ON for machines with an autodoor. Refer to M80 / M81 (Auto Door Open / close M-codes) on page M80 Auto Door Open / M81 Auto Door Close.

note: The M-codes work only while the machine receives a cell-safe signal from a robot. For more information, contact a robot integrator.

The door closes when CYCLE START is pressed and opens when the program reaches an M00, M01 (with Optional Stop turned ON), or M30 and the spindle has stopped turning.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback