Classic Haas Control (CHC) - Show only the Offsets that are in the Program

If the setting 201 is ON, the TOOL and WORK offset tables show only the offsets that the last program used.

You must start your program in GRAPHICS mode to use this function.

Push F3 to cancel this function and see all of the offsets.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback