Classic Haas Control (CHC) - Make a Copy of a Program

To make a copy of a program in memory:

  1. Push LIST PROGRAM to go to the Device Manager.

  2. Select the MEMORY tab.

  3. Select the program.

  4. Type a new program name (Onnnnn) and push F2.

    This makes a copy of the selected program. The copy becomes the active program.

  5. To make a copy onto a different device, select the program and push F2. Do not type a program number.

    A popup menu shows devices where you can put the copy.

  6. Select a device and push ENTER.

  7. To copy more than one file, push ENTER to put a check mark at each file name.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback