Read Before Operating

Next Generation Control Mill Operator's Manual

The Online Interactive Operator's Manual is currently available in English only.

A PDF version of the Operator's Manual is available for download in multiple languages. Click the link below to view the Operator's Manual in your language. Click "Continue" to view the online version in English.

Get a translated PDF Download Continue
danger: Do not enter the machining area any time the machine is in motion, or at any time that machine motion is possible. Severe injury or death may result. Motion is possible when the power is on and the machine is not in EMERGENCY STOP.

Basic safety:

  • This machine can cause severe bodily injury.
  • This machine is automatically controlled and may start at any time.
  • Consult your local safety codes and regulations before you operate the machine. Contact your dealer if you have questions about safety issues.
  • It is the machine owner’s responsibility to make sure that everyone who is involved in installing and operating the machine is fully acquainted with the operation and safety instructions provided with the machine, BEFORE they work with the machine. The ultimate responsibility for safety rests with the machine owner and the individuals who work with the machine.
  • Use appropriate eye and ear protection when you operate the machine.
  • Replace windows immediately if they are damaged or severely scratched.
  • Keep the side windows locked during operation (if available).

Electrical safety:

  • The electrical power must meet the required specifications. Attempting to run the machine from any other source can cause severe damage and will void the warranty.
  • The electrical panel should be closed and the key and latches on the control cabinet should be secured at all times, except during installation and service. At those times, only qualified electricians should have access to the panel. When the main circuit breaker is on, there is high voltage throughout the electrical panel (including the circuit boards and logic circuits) and some components operate at high temperatures; therefore, extreme caution is required. Once the machine is installed, the control cabinet must be locked, with the key available only to qualified service personnel.
  • Do not reset a circuit breaker until the reason for the fault is investigated and understood. Only Haas-trained service personnel should troubleshoot and repair Haas equipment.
  • Do not press POWER UP/RESTART on the control pendant before the machine is fully installed.

Operation Safety:

  • Do not operate the machine unless the doors are closed and the door interlocks are functioning correctly.
  • Check for damaged parts and tools before you operate the machine. Any part or tool that is damaged should be properly repaired or replaced by authorized personnel. Do not operate the machine if any component does not appear to be functioning correctly.
  • Improperly clamped parts machined at high speeds/feeds may be ejected and puncture the enclosure. It is not safe to machine oversized or marginally clamped parts.

Follow these guidelines when you work with the machine:

  • Normal operation - Keep the door closed and guards in place (for non-enclosed machines) while the machine operates.
  • Part loading and unloading – An operator opens the door, completes the task, closes the door, and then presses CYCLE START (starting automatic motion).
  • Machining job set-up – Press EMERGENCY STOP before you add or remove machine fixtures.
  • Maintenance / Machine Cleaner– Press EMERGENCY STOP or POWER OFF on the machine before you enter the enclosure.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback