Pendant - LED Beacon Light - Replacement

Applies to machines built from: 
July, 2008
AD0336 Rev C

Pendant - LED Beacon Light - Replacement

This procedure tells you how to replace an LED beacon light on a control pendant.

Remove the control pendant back panel. Disconnect the P10 cable [4] from the control pendant SKBIF.

Disconnect the J13 cable [2] and the J16 cable [3]. Remove the "Power Off" contactor [1]. Remove the LCD monitor assembly [5].

Remove the (3) LED beacon light screws [6] and the LED beacon light [7]. Replace the LED beacon light [7]. Install the components in the opposite order they were removed.

Prerequisites

This procedure is applicable to more than one kit. Only one of the kits in the "Parts Included" section is necessary.

Parts Included

KIT
93-32-5131
QTY: 1
BEACON, LIGHT ASSEMBLY 2 LED
KIT
93-0680
QTY: 1
BEACON, ASSEMBLY 4 LED
KIT
93-3028
QTY: 1
BEACON, LIGHT 12 LED ASSEMBLY

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback