Bar Feeder - Bar-Loading Motor - Replacement

Applies to machines built from: 
January, 1999

Bar Feeder - Bar-Loading Motor - Replacement

Step 1

Remove the Bar Transfer Table (V-tray) before you remove motor.

Disconnect the motor cables. Remove the (2) set screws [1] that lock the motor shaft to the clutch.

Step 2

Remove the (4) bolts [1] that attach the motor to the chassis.

Pull the motor straight back. Make sure you do not lose the motor key.

Replace the motor. Install the components in the opposite order that they were removed.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback