How To>M17 Unclamp APC Pallet and Open APC Door / M18 Clamp APC Pallet and Close APC Door - Lathe

M17 Unclamp APC Pallet and Open APC Door / M18 Clamp APC Pallet and Close APC Door - Lathe

M17 Unclamp APC Pallet and Open APC Door / M18 Clamp APC Pallet and Close APC Door
M17 and M18 rotate the turret in the forward (M17) or reverse (M18) direction when a tool change is made. The following M17 program code causes the tool turret to move forward to tool 1 or reverse to tool 1 if an M18 is commanded.
N1 T0101 M17 (Forward) ;
N1 T0101 M18 (Reverse) ;

An M17 or M18 stays in effect for the remainder of the program.

note: Setting 97, Tool Change Direction, must be set to M17/M18.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback