G47 Text Engraving (Group 00)

Classic Control - Mill Operator's Manual

The Online Interactive Operator's Manual is currently available in English only.

A PDF version of the Operator's Manual is available for download in multiple languages. Click the link below to view the Operator's Manual in your language. Click "Continue" to view the online version in English.

Get a translated PDF Download Continue

G47 lets you engrave a line of text, or sequential serial numbers, with a single G-code. To use G47, Settings 29 (G91 Non-Modal) and 73 (G68 Incremental Angle) must be OFF.

note: Engraving along an arc is not supported.
*E - Plunge feed rate (units/min)
F - Engraving feedrate (units/min)
*I - Angle of rotation (-360. to +360.); default is 0
*J - Height of text in in/mm (minimum = 0.001 inch); default is 1.0 inch
P - 0 for literal text engraving
- 1 for sequential serial number engraving
- 32-126 for ASCII characters
*R - Return plane
*X - X start of engraving
*Y - Y start of engraving
*Z - Depth of cut

*indicates optional

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback