Disabling and Enabling Rotary Axes

Next Generation Control Mill Operator's Manual

The Online Interactive Operator's Manual is currently available in English only.

A PDF version of the Operator's Manual is available for download in multiple languages. Click the link below to view the Operator's Manual in your language. Click "Continue" to view the online version in English.

Get a translated PDF Download Continue

A disabled rotary axis does not move, but it stays configured. Disabling a rotary axis is a good way to temporarily stop using a rotary axis without removing it completely from the machine.

Enabled rotary axes appear with a filled-in checkbox in the Current Rotary Selections table.

[1] Enabled Rotary Axis, [2] Disabled Rotary Axis.

  1. Highlight the axis you want to disable or enable.
  2. Press EMERGENCY STOP.
  3. Press ENTER.
    note: The control must not be in Jog mode when you disable an axis. If you get a Wrong Mode message, press MEMORY to change modes, and then press SETTING to return to the Rotary page.

    The control toggles the enabled state of the rotary axis.

  4. Release EMERGENCY STOP to continue operation.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback