Deleting Programs

Classic Control - Mill Operator's Manual

The Online Interactive Operator's Manual is currently available in English only.

A PDF version of the Operator's Manual is available for download in multiple languages. Click the link below to view the Operator's Manual in your language. Click "Continue" to view the online version in English.

Get a translated PDF Download Continue
note: You cannot undo this process. Be sure to have backups of data that you may want to load on the control again. You cannot press UNDO to recover a deleted program.
  1. Press LIST PROGRAM and select the device tab that contains the programs you want to delete.
  2. Use the UP or DOWN cursor arrows to highlight the program name.
  3. Press ERASE PROGRAM.
    note: You cannot delete the active program.
  4. Press Y at the prompt to delete the program, or N to cancel the process.
  5. To delete multiple programs: highlight each program you want to delete and press ENTER. This places a check mark next to each program name. Press ERASE PROGRAM. Answer the Y/N prompt for each program.
  6. If you want to delete all of the programs in the list, select ALL at the end of the list and press ERASE PROGRAM.
    note: There are some important programs that may be included with the machine, such as O02020 (spindle warm-up) or macro programs (O09XXX). Save these programs to a memory device or PC before you erase all programs. You can also use Setting 23 to protect O09XXX programs from deletion.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback