28 - Can Cycle Act w/o X/Y

Classic Control - Lathe Operator's Manual

The Online Interactive Operator's Manual is currently available in English only.

A PDF version of the Operator's Manual is available for download in multiple languages. Click the link below to view the Operator's Manual in your language. Click "Continue" to view the online version in English.

Get a translated PDF Download Continue

This is an ON/OFF setting. The preferred setting is ON.

When it is OFF, the initial canned cycle definition block requires an X or Y code for the canned cycle to be executed.

When it is ON, the initial canned cycle definition block causes one cycle to be executed even when there is no X or Y code in the block.

note: When an L0 is in that block, it will not execute the canned cycle on the definition line. This setting has no effect on G72 cycles.

Be aware: Many service and repair procedures should be done only by authorized personnel. The service technicians at your Haas Factory Outlet (HFO) have the training, experience, and are certified to do these tasks safely and correctly. You should not do machine repair or service procedures unless you are qualified and knowledgeable about the processes.

Danger: Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not completely understand. Contact your Haas Factory Outlet (HFO) and schedule a service technician visit if you have any doubts about doing a procedure.

Feedback